Hi All.
Would anybody know the dimensions of the seating washer to torque up the cv joint/front wheel bearing (tool21 on minispares).
Or even better, does anybody have one that they could lend me for a day?
Thanks
Ciaran
Welcome to the Irish Mini Owners Club Forum. To aid the prevention of the spread of the Covid - 19 Virus. With the greatest of respect for our Members, families and general public. We have taken the conscious decision to postpone all runs, meets and events until further notice
CV Joint seating washer
Moderators: irishminis, spud1979, The Marcos Graveyard, admin, woody, Moderators
-
- NON Member
- Posts: 42
- Joined: Sun May 15, 2011 10:56 pm
- Whats your location?: Dublin
- Region: Eastern
- Contact:

Re: CV Joint seating washer
There is a drawing & description in your Haynes Manual in the chapter on 'Driveshafts'. It is cut from 1/4in. - 6.5mm sheet steel or a washer with a Diameter of 50mm & a centre hole of 25mm. Don't use anything thinner as you will not be able to pull the CV joint tight. Eamonn.
-
- NON Member
- Posts: 42
- Joined: Sun May 15, 2011 10:56 pm
- Whats your location?: Dublin
- Region: Eastern
- Contact:
Re: CV Joint seating washer
Eamonn you absolute gentleman. I moved house and couldnt find the Haynes manual anywwhere. Probably still at the bottom of a box.
I was able to get a very very similar sized washer in Tripart in galway this morning. Thanks again. Should be back on the road in the morning.
Ciaran
I was able to get a very very similar sized washer in Tripart in galway this morning. Thanks again. Should be back on the road in the morning.
Ciaran
Who is online
Users browsing this forum: No registered users and 3 guests